Hayabusa Gen2 Camshaft Pair 260/248 Regrind

Description

Hayabusa Gen 2 Camshaft Pair Regrind Inlet:260deg/9.70mm lift, Exhaust:248deg/9.30mm lift

CM-BUSA-13R2

This profile for the Gen 2 Hayabusa engine is achieved by using two standard Hayabusa Gen 2 cams (supplied by customer), which are then reground.

This gives a good increase in horsepower and torque yet still retaining standard springs & caps.
Expected performance gains 20+BHP* (*this depends on the engine build, more or less can be gained depending on total spec of your engine)

To achieve the best performance from these camshafts, we recommend between 13:1 to 14:1 compression ratio. You will mostly likely need to modify the pistons if you are using standard pistons to ensure there is sufficient valve to piston clearance. You may not be able to reach the optimum compression with the stock piston but you will still get good performance gains even if using the standard pistons.

We only recommend the use of our cam profiles with vernier cam pulleys so you can optimise the cam timing and during the build, you must check valve to piston clearance and modify the pistons or replace with a competition piston if extra clearance is required. We recommend a minimum of 40-60thou (1-1.5mm).

If you are attempting to increase the compression ratio, the Hayabusa as standard normally has a large squish sometimes in excess of 40thou (1mm), we recommend a minimum of 30thou but this will obviously reduce your valve to piston clearance so care will need to be taken and careful measuring should be taken by the engine builder.

Please note

In order to grind the CM-BUSA-13R2 profiles the Customer must provide a pair of standard Hayabusa Gen 2 cams. We sometimes have in stock Hayabusa cams, please see related products below.

Please see instruction sheets for information regarding the camshafts, their installation & running in.